How Do You Jump Start a Car?

To jump start a car, connect the red lead to the flat battery's positive terminal, then to the donor battery's positive terminal. Connect the black lead to the donor battery's negative terminal, then clamp the other black end to bare, unpainted metal on the flat car's engine block or chassis, away from the battery. Start the donor car, let it run for a few minutes, then start the flat car. Remove the leads in the exact reverse order. That is how to jump start a car safely with jumper leads. A jump pack follows the same red then black order without a second car. If you drive a hybrid, EV or European model, check the owner's handbook first.
What You Need Before You Start
You need one of two things: a set of jumper leads and a donor vehicle with a healthy battery, or a charged portable jump pack. Lithium jump packs are compact, hold their charge for months, and let you start a car without waiting for help.
If you use leads, check they are in good condition, with no split insulation or damaged clamps. Heavier gauge leads handle the current better. The donor vehicle should have a battery of the same voltage, which is 12 volts on almost every passenger car.
Before you connect anything, look after the basics. Park somewhere safe and off the road if you can, with hazard lights on. Put both vehicles in park or neutral with the handbrake on, and switch off both ignitions, lights and accessories. Remove loose scarves or jewellery, keep naked flames and cigarettes well away, and never lean directly over a battery. Batteries can give off hydrogen, which is flammable.
How to Jump Start a Car Step by Step
1. Park the donor car close enough for the leads to reach, without the vehicles touching, and switch off both ignitions.
2. Connect one red clamp to the positive (+) terminal of the flat battery.
3. Connect the other red clamp to the positive (+) terminal of the donor battery.
4. Connect one black clamp to the negative (-) terminal of the donor battery.
5. Connect the other black clamp to solid, unpainted metal on the flat car's engine block or chassis, well away from the battery and fuel system.
6. Start the donor car and let it run for a few minutes.
7. Start the flat car, cranking for no more than about five seconds at a time. If it does not start, wait a couple of minutes and try again.
8. Once it runs, remove the leads in reverse order: black from the earth point, black from the donor, red from the donor, then red from the jump started car. Keep the clamps apart.
The final connection often sparks. Making it on the engine, away from the battery, keeps that spark clear of any hydrogen the battery gives off.
How to Jump Start a Car Using a Jump Pack
A portable jump pack is now the easiest way for many drivers to get going, and it removes the risks that come with connecting two vehicles together.
Make sure the pack is charged and switched off. Connect the red clamp to the flat battery's positive (+) terminal, then connect the black clamp to an earth point on the engine block or chassis, or to the location the pack's instructions specify. Switch the pack on and start the car, cranking for no more than about five seconds at a time. Once the engine is running, switch the pack off and remove the black clamp first, then the red.
Many jump packs include reverse polarity and spark protection, which adds a margin of safety on modern vehicles. Follow the maker's instructions, rest the pack somewhere stable rather than on the engine, where it could fall once the engine starts, and recharge it soon after use so it is ready next time.
What Not to Do When Jump Starting
Never reverse the polarity. Connecting positive to negative can damage the battery, blow fuses and harm the electronics on both vehicles. Check every terminal marking before you clamp on.
Never try to jump start a battery that is cracked, leaking, swollen or badly corroded. A damaged battery can fail violently. Call for help instead.
Do not let the clamps touch each other, or touch any other metal, once any lead is connected. Do not connect the final black clamp to the flat battery's negative terminal, because that puts the spark right beside the battery.
Do not rev the donor engine hard. A steady idle, or a gentle hold just above it, is enough.
Take extra care with modern cars. They rely on control modules for everything from the engine to the airbags, and a careless jump start can damage these systems. Follow the owner's handbook, use any dedicated jump points, and keep every step in the correct order.
Vehicles You Should Not Jump Start the Usual Way
Hybrids and EVs still have a conventional 12 volt battery that powers the electronics and wakes the car's systems. If that battery goes flat, the car will not switch on. Many hybrids and EVs allow the 12 volt system to be jump started, sometimes through a dedicated jump terminal under the bonnet rather than at the battery itself. The high voltage drive battery and its orange cables must never be touched. Do not use a hybrid or EV as the donor car unless the manufacturer's handbook says you can.
Vehicles with engine start stop usually run AGM or EFB batteries and often have a battery sensor on the negative terminal. They can generally be jump started, but make the final black connection to the engine earth point rather than the battery's negative terminal.
Many European models have the battery in the boot or under a seat. They provide a dedicated positive jump post and earth point under the bonnet, often under a cover marked with a plus sign. Use those points, not the battery.
What to Do Once the Car Starts
Once the engine is running and the leads are off, do not switch it straight back off. The battery needs time to recover some charge, and the engine is what recharges it.
Take the car for a proper drive, at least 30 minutes at normal speeds rather than a few minutes of stop start traffic. A short trip around the block will not put back what the starter motor just took out, and you may find yourself needing another jump start the next time you turn the key.
Then get the battery and charging system tested. A car that needed a jump once will usually need one again, because a flat battery is a symptom of something: an ageing battery, a charging fault or an electrical drain. A battery test shows whether the battery can still hold a charge, and an auto electrical check can confirm the alternator and wiring are doing their job.
Why Did the Battery Go Flat?
Sometimes the cause is obvious, such as headlights or an interior light left on overnight. Other times it points to a battery near the end of its life, a charging system that is not keeping up, or something draining power while the car is parked. Knowing which one it is saves you from being stranded again. Our guide to how long car batteries last covers the warning signs, and a battery test will give you a clear answer.
Flat Batteries on New Zealand Roads
Cold mornings are hard on batteries. When temperatures drop in winter, a battery has less power available just when the engine needs more effort to turn over, which is why flat batteries tend to show up on the first frosty mornings of the year.
Short urban trips cause problems all year round. A quick run to school or the shops uses a lot of energy to start the engine but rarely lasts long enough to replace it, so the battery slowly runs down.
In rural areas, a flat battery is more than an inconvenience. The distance between towns can be long, mobile coverage can be patchy, and help may be some way off. Carrying a charged jump pack is worth considering if you drive long distances. Auto Super Shoppe Roadside Assistance also includes jump starts for flat batteries, 24 hours a day, nationwide.
Get Your Battery Checked at Your Nearest Auto Super Shoppe
If your car has needed a jump start, or it is turning over slowly on cold mornings, have the battery and charging system checked before it lets you down again. Our qualified mechanics will test the battery, check the charging system, and give you an honest answer on what needs attention now and what can wait.
Find your closest workshop at autosupershoppes.co.nz or call 0800 AUTO HELP (0800 288 643). With 120+ MTA Approved workshops from Northland to Invercargill, there is a Shoppe near you.

Frequently Asked Questions
Which terminal do you connect first when jump starting?
Connect the red lead to the positive (+) terminal of the flat battery first. Then connect the other red end to the donor battery's positive terminal, the black lead to the donor battery's negative terminal, and finally the other black end to an unpainted metal earth point on the flat car's engine block or chassis. When you disconnect, remove the leads in the exact reverse order, starting with the black clamp on the earth point.
Can you jump start a car on your own without another car?
Yes, you can jump start a car on your own with a portable jump pack. Connect the red clamp to the flat battery's positive terminal and the black clamp to an earth point or the location the pack's instructions specify, then switch the pack on and start the car. Keep the pack charged, because a flat jump pack will not help. Roadside assistance is another option if you do not have a pack with you.
How long should you leave a car running after a jump start?
Drive the car for at least 30 minutes after a jump start, at normal speeds rather than in stop start traffic. Leaving it idling in the driveway for a few minutes does little to recharge the battery. Even after a good drive, the battery may not be fully recovered, so have the battery and charging system tested to find out why it went flat in the first place.
Can you jump start a hybrid or electric car?
In many cases you can jump start the 12 volt battery in a hybrid or electric car, but you must follow the owner's handbook. Some models have a dedicated jump terminal under the bonnet rather than an accessible battery. Never touch the high voltage drive battery or its orange cables. Do not use a hybrid or EV as a donor vehicle to jump another car unless the manufacturer says it is safe.
Is it safe to jump start a modern car?
Jump starting a modern car is generally safe when you follow the correct order and the owner's handbook. Modern vehicles rely on sensitive control modules, so avoid reversed polarity, keep the clamps apart, and make the final connection to an engine earth point rather than the battery. Use any dedicated jump points the manufacturer provides. A jump pack with reverse polarity protection adds a useful margin of safety.
Why won't my car start even after a jump start?
If a car will not start after a jump start, the problem may not be the battery. First check the clamps have a firm grip on clean terminals, since a poor connection is common. If the engine cranks strongly but will not fire, look at fuel, ignition or the immobiliser. If you hear a single click or nothing at all, the starter motor or wiring may be at fault. A mechanic can find the cause quickly.
This article was written by the Auto Super Shoppes team. Auto Super Shoppes is New Zealand's largest network of MTA Approved automotive workshops, with 120+ locally owned Shoppes nationwide.


